The major function of the shaft sleeve is to protect the shaft from packing wear around the stuffing box. Shaft sleeves are normally used in single-stage pumps. In these pumps, the sealing gland and the impeller are not directly attached to the shaft. The sleeve is attached in between the impeller's bore.

Shaft Sleeves are available for Kirloskar Pumps, KSB Pumps, Beacon Pumps, Mather Platt (Wilo) Pumps, etc Shaft Sleeve M.O.C. – EN8, EN19, C.I, S.S 410, S.S 304, S.S 316, Bronze etc.

We are suppliers of all type of Shaft Sleeves of Centrifugal Pump s. Shaft Sleeve M.O.C. - EN8, EN19, C.I, S.S 410, S.S 304, S.S 316, Bronze etc. Manufactured from best quality raw materials, the SHaft Sleeves are available in different grades and sizes as per the needs of our esteemed customers.

Tobee® Mission Magnum 4x3x13 Pump Shaft Sleeve 20943-21A, Shaft Sleeve 20943-21 for Mechanical Seal Pump, China NOV Mission Magnum Pump Shaft Sleeve, 

Retailer of Shaft Sleeves - Pump Shaft Sleeve offered by Mahi Engineering, Vadodara, Gujarat.

The sleeve allows a wearable and replaceable surface. This is a more effective approach to pump repair. It allows a more cost-effective and time savings when compared with having to replace a complete shaft assembly. It is completely interchangeable with over a dozen ansi pump brands and designs. In fact, many boast that this sleeve is probably

WHY USE GADROCK® SHAFT SLEEVES OVER BRONZE or STAINLESS? The GADROCK® sleeve is an alternative to the bronze and stainless steel sleeve.

A shaft sleeve is located either partly or fully inside a pump housing which is of plastics construction, and surrounds the shaft driving the pump impeller. A seal is located in the region of the shaft sleeve. The shaft sleeve (7) is of plastics and seals against the impeller (2) under the force of the seal (8,9).The sleeve is located form binding with the shaft, via polygonal surfaces

James P. Netzel, in Centrifugal Pumps (Second Edition), 1992 Adaptive Hardware. Structural parts of a seal installation such as shaft sleeve, gland plates, bushings, and collars used to fit a seal

An impeller. A volute or diffuser style casing. A shaft. Shaft sleeves. Bearings. A sealing arrangement. These parts can be subdivided into the wet end and the mechanical end. This article is part of Pumps 101, an eleven-part series of articles designed as an introduction to the fundamentals of centrifugal pump design, selection, and application.

Shaft sleeves are cylindrical metal tubes designed to protect pump shafts from erosion, corrosion, and wear at critical points, such as at the stuffing box. The shaft sleeve is a wear component, like brake pads on a car, and is designed to be more time and cost efficient to replace than the shaft itself (like the entire braking system).